Air filter, Cleaning the air filter, Oiling the air filter – English Leather 245R/RX User Manual
Page 30: Bevel gear, Maintenance
30 –
English
MAINTENANCE
Air filter
The air filter must be regularly cleaned to remove dust and dirt
in order to avoid:
•
Carburettor malfunctions
•
Starting problems
•
Loss of engine power
•
Unnecessary wear to engine parts
•
Excessive fuel consumption.
Clean the filter every 25 hours, or more regularly if conditions
are exceptionally dusty.
Cleaning the air filter
240R, 245R/RX
Remove the air filter cover and take out the filter. Wash it
clean in warm, soapy water. Ensure that the filter is dry before
refitting it.
If the machine is used in dusty conditions the air filter should
be soaked in oil. See instructions under the heading Oiling the
air filter.
250R, 252RX
Remove the air filter cover and remove both filters, A and B.
A is an air filter and B is a pre-filter. Both must be washed in
warm soapy water and dried. Filter A must then be soaked in
oil, see instructions under the heading Oiling the air filter.
265RX
Remove the air filter cover and take out the filter. Wash it
clean in warm, soapy water.
Ensure that the filter is dry before refitting it.
Oiling the air filter
Always use HUSQVARNA filter oil, art. no. 531 00 92-48. The
filter oil contains a solvent to make it spread evenly through
the filter. You should therefore avoid skin contact.
Put the filter in a plastic bag and pour the filter oil over it.
Knead the plastic bag to distribute the oil. Squeeze the
excess oil out of the filter inside the plastic bag and pour off
the excess before fitting the filter to the machine. Never use
common engine oil. This would drain through the filter quite
quickly and collect in the bottom.
An air filter that has been in use for a long time cannot be
cleaned completely. The filter must therefore be replaced with
a new one at regular intervals. A damaged air filter must
always be replaced.
Bevel gear
The bevel gear is filled with the right quantity of grease at the
factory. However, before using the machine you should check
that the bevel gear is filled three-quarters full with grease. Use
HUSQVARNA special grease.
The grease in the bevel gear does not normally need to be
changed except if repairs are carried out.
B
A