Elecom UCAM-B1C30TBK SETUP GUIDE - Manual (Page 3)

2 3
4.
Select "完全" and then click on the
button.
5.
Click on the button.
Installation will begin.
6. Click on the button.
7. Peel off the sticker from the USB connec-
tor of the PC camera.
8.
Plug the USB connector of the PC cam-
era into a USB port of the PC.
Though this PC camera consumes a
maximum 100 mA of power, because of
specifications, connect it to a USB port
that supplies 500 mA.
The PC camera may be connected
and disconnected while power to the
PC is ON.
Do not try plugging the USB connector
in upside-down.
This completes Driver Utility installation.
Next, check that the Driver Utility was correctly
installed. Go to pg. 10.