Epson ACULASER C3800 - Manual (Page 176)

Using the Control Panel 176
EPSON AcuLaser C3800 User's Guide
*1
Available only when the optional paper cassette unit is installed.
*2
Available only for the models with Duplex Unit.
*3
Available only when you use A4, A5, B5, LT, LGL, EXE, or GLG size paper.
*4
Available only for ESC/Page, ESC/P2, FX, or I239X mode.
*5
Not available for models with Duplex Unit.
*6
After this setting is changed, the printer will automatically reboot and the new setting takes effect.
*7
After this item is changed, the setting value takes effect after a warm boot or after the power is turned on
again.
Language
Specifies the language displayed on the LCD panel and that printed on the status sheet.
Time to Sleep
Specifies the length of time until the printer enters the sleep mode if there are no button
operations.
Time Out
Specifies the length of the time, in seconds, before a time out when interfaces are being
switched automatically. The time before a time out occurs is the length of time from the
point when no data is being received from an interface until the point of switching the
interface. If the printer has a print job when switching the interface, the printer prints the
print job.
Paper Source
Specifies whether paper feeds into the printer from the MP tray or the optional paper
cassette unit.
If you select Auto, paper feeds from the paper source containing paper that matches your
Paper Size setting.
If an envelope size (DL, C5, IB5) is selected as the Page Size setting, paper always feeds
from the MP tray. If you select Thick, ExtraThk, or Trnsprncy as the Paper Type setting,
paper always feeds from the MP tray.
MP Mode
This setting determines whether the MP tray has the highest or lowest priority when Auto
is selected as the Paper Source setting in the printer driver. When Normal is selected as
the MP Mode, the MP tray has the highest priority as the paper source. If you select Last,
the MP tray has the lowest priority.
RAM Disk
*7
Off, Normal, Maximum