Panasonic Lumix DMC-LX10K - Manual (Page 58)

58
Others
SQT1380 (ENG)
It cannot connect to the wireless LAN. Radio waves get disconnected.
Wireless access point is not displayed.
General tips for using a Wi-Fi connection
• Use within the communication range of the wireless LAN network.
• If any device, such as microwave oven, cordless phone, etc., that uses 2.4 GHz frequency
are used nearby this unit simultaneously, radio waves may get interrupted.
→ Use them sufficiently away from the device.
• When the battery indicator is flashing red, the connection with other equipment may not
start or the connection may be disrupted. (A message such as [Communication error] is
displayed.)
• When this unit is placed on a metal table or shelf, the connection may not be established
easily because the camera is affected by radio waves. Use the camera away from metal
surfaces.
About a wireless access point
• Check if the wireless access point to connect is in operating state.
• Check the radio wave condition of the wireless access point.
→ Perform the connection closer to the wireless access point.
→ Move the location or change the angle of the wireless access point.
• It may not display even if the radio waves exist depending on the setting of the wireless
access point.
→ Turn off the wireless access point and then turn it back on.
• If the network SSID of the wireless access point is set not to broadcast, it may not be
detected.
→ Enter and set the network SSID. Alternatively, set the network SSID of the wireless access
point to broadcast.