Levelling the appliance – Electrolux SG306 User Manual

Page 32

Advertising
background image

32

If the units are intended to be fitted

adjacent to the appliance but less

than 400mm above the hotplate,

then a minimum space of 100mm

must be maintained between the

sides of the unit and the appliance

(See Fig 1b). Curtains must not be

fitted immediately behind the

appliance or within 150mm of the

sides of the hotplate. If fitted next to

or between two base units a

minimum space of 1mm must be left

between each unit and the sides of

the appliance. The hotplate must be

set to a minimum of 7mm above the

adjacent units. (Note: The levelling

feet fitted to the appliance will

achieve a nominal height of 907mm

-5+ 13mm. Base units not meeting

the above conditions must be a

minimum of 100mm away from the

hotplate.

For appliances installed in the

Republic of Ireland please refer to

NSAI-Domestic Gas Installation

IS813 Current Edition Section7

Permitted Locations of appliance

Table4---Locations and Permanent

Ventilation

requirements-flueless

appliances.

Note: - L.P.G. cookers MUST NOT

be installed below ground level i.e. in

a basement or aboard any boat,

yacht or other vessel.

Levelling the appliance

Adjustment to suit floor conditions or

height is obtained by rotating

clockwise or anti clockwise the feet

at the front and rear of the

appliance. A spirit level should be

placed on one of the shelves to

confirm the appliance is correctly

levelled.

Advertising