Casio Firmware Update - Manual (Page 5)

5
CASIO Projector Flash Loader Error Messages
Error Message Possible Cause and Required Action
There is a problem with the file
format.
ID-01 There may be something wrong with the firmware data.
Download the firmware update for your projector again and then perform the
procedure under “To update projector firmware” again.
A connection could not be
established with the projector.
Check the USB cable
connection, turn the projector
off and then back on, and then
try again.
ID-02 Could not connect with the projector. Check the points below.
z Is the USB driver installed on the computer? See “To install the USB driver”.
z Is the USB cable connected correctly to the computer and the projector?
z Is the projector turned on?
This is not a new ROM version.
ID-03 The version of the firmware you are trying to install is lower (earlier) or the same
as the projector’s current firmware. You can only install firmware whose version
is higher (later) than the projector’s current firmware.
This ROM data is for a different
model.
ID-04 You are attempting to install a firmware for a different projector model.
Check to make sure that the firmware data you are trying to install is correct.