Powerplus POWXQG7570 LAWNMOWER 160CC 510MM EN - Manual (Page 15)

POWXQG7570 EN
Copyright © 2013 VARO P a g e | 15 www.varo.com
 If the starter rope becomes disconnected from rope guide on handle, disconnect and
ground the spark plug wire, Depress the blade control handle and pull the starter rope out
from engine slowly. Slip the starter rope into the rope guide bolt on handle.
10 TRANSPORT
Turn the engine off. Ensure not to bend or damage the cutter when pushing the lawnmower
over obstacles.
11 TROUBLES SHOOTING
PROBLEM PROBABLE CAUSE CORRECTIVE ACTION
Engine does
not start. Throttle chock not in the correct
position for the prevailing conditions. Move throttle chock to correct
position
Fuel tank is empty. Fill tank with fuel
Air cleaner element is dirty. Clean air cleaner element
Spark plug loose. Tighten spark plug to 25-30 Nm.
Spark plug wire loose or
disconnected from plug. Install spark plug wire on spark plug.
Spark plug gap is incorrect. Set gap between electrodes at 0.7 to
0.8mm
Spark plug is defective Install new, correctly gapped plug
Carburetor is flooded with fuel Remove air cleaner element and pull
starter rope continuously until
carburetor clears itself and install air
cleaner element.
Faulty ignition module Contact the service agent.
Engine
difficult to
start or loses
power. Dirt, water, or stale fuel tank. Drain fuel and clean tank. Fill tank
with clean, fresh fuel
Vent hole in fuel tank cap is plugged. Clean or replace fuel tank cap.
Air cleaner element is dirty. Clean air cleaner element.
Engine
operates
erratically. Spark plug is defective. Install new, correctly gapped plug
Spark plug gap is incorrect. Set gap between electrodes at 0.7 to
0.8mm
Air cleaner element is dirty. Clean air cleaner element
Engine idles
poorly. Air cleaner element is dirty. Clean air cleaner element
Air slots in engine shroud are
blocked. Remove debris from shots.
Cooling fins and air passages under
engine blower housing are blocked. Remove debris from cooling fins and
air passages.
Engine skips
at high
speed. Gap between electrodes of spark plug
is too close. Set gap between electrodes at 0.7 to
0.8mm
Engine
overheats Cooling air flow is restricted. Remover any debris from slots in
shroud, blower housing, air
passages
Incorrect spark plug. Install RJ19LM spark plug and
cooling fins on engine
Mower
vibrates Cutting assembly is loose. Tighten blade
Cutting assembly is unbalanced Balance blade.