Powerplus POWXQG7570 LAWNMOWER 160CC 510MM EN - Manual (Page 9)

POWXQG7570 EN
Copyright © 2013 VARO P a g e | 9 www.varo.com
Replace all fuel tanks and container caps securely.
Before tipping the lawn mower to carry out any work on the blade or drain oil, remove fuel from
tank.
WARNING: never fill fuel tank indoors, with engine running or until the
engine has been allowed to cool for at least 15 minutes after running.
7.2 To start engine and engage blade
Fig 6A Fig 6B
Fig 6C Fig 6D
1. The unit is equipped with a rubber boot over the end of the spark plug, make certain the
metal loop on the end of the spark plug wire (inside the rubber boot) is fastened securely
over the metal tip on the spark plug.
2. Before starting engine, please turn the fuel cock to the “ ”position. (Fig.6A)
3. When starting engine, turn throttle choke lever to “ ”position. (Fig.6B)
4. Standing behind the unit, grasp the brake control handle and hold it against the upper
handle as shown in fig. 6C.
5. Grasp the starter handle as shown Fig. 6C and pull up rapidly. Return it slowly to the rope
guide bolt after engine starts. Release the brake control handle to stop the engine and
blade.
6. After starting the engine , then you want to cut grass quickly, please turn throttle choke
lever to “ ”position. (Fig.6B) If you want to cut grass slowly, please turn throttle
choke lever to “ ” (Fig.6B).
7. When you finis h the job of mowing each time, please turn the fuel cock to the” ”.
(Fig.6D)