Crivit 1-LD3604-х - Manual (Page 30)

- 57 -
Setup
Remove the protective film from the display and press MODE, SEL or SET.
Now select English or German language by pressing SEL and confirm your setting
by pressing SET. Select the unit KM-KG or Miles/pounds (M-LB) in the same way.
Complete the setting procedure by pressing MODE.
The watch can be reset by pressing and holding SET and SEL together. Only after
reseting the watch the other language can be selected.
Using the bicycle holder
The included bicycle holder can be used to attach the heart rate monitor to the
handlebar of a bicycle. Press the bicycle holder onto the top of the handlebar.
Handlebars with an especially large diameter may require the use of additional
force to snap on the bicycle holder. The heart rate monitor can now be attached to
the bicycle holder in the same way that you would attach it to your wrist.
The maximum range of 60cm between the heart rate monitor and the chest belt
should not be exceeded.
Please note that the pedometer features of the heart rate monitor (distance, speed
etc.) will not be functional while the watch is mounted on the bicycle holder.
- 58 -
Light
Briefly press LIGHT to temporarily activate the light.
Important notes on the operation of the heart rate
monitor
The watch has 4 different modes of operation.
Press MODE to select the mode of operation of the watch.
The order of the modes is as follows:
time and basic settings (ZEIT/TIME)
stop watch (ST-UHR/CHRONO)
heart rate (PULS/HRM)
pedometer (PEDO)
Each mode of operation may have several subfeatures.
The subfeatures can always be accessed by pressing SEL.
Speed setting
When setting numerical values, press and hold SEL to use the speed setting
feature.
Time and basic settings (ZEIT/TIME)
Press MODE to select the (ZEIT/TIME) feature before proceeding.
The subfeatures of the time mode can be accessed by pressing SEL.
time and basic settings (ZEIT/TIME) > alarm (ALARM) > timer (TIMER)
Press and hold SET for 3 seconds to access setting mode.
The display will show EINSTELLEN/HOLD TO SET and the 12 or 24 hour
selection will blink on the display.