Crivit 1-LD3604-х - Manual (Page 32)

- 61 -
Heart rate measurement (PULS/HRM)
The subfeatures of the heart rate measurement can only be used when the chest
belt is connected.
Press MODE to select the (PULS/HRM) feature before proceeding.
Press SEL to access the subfeatures of the heart rate watch.
Timer (TIMER) > Memory feature (SPEICHER/MEMORY) > target heart rate
(ZONE) > calories burned, fat burned and BMI (KALORIEN/CALORIE) >
pedometer (PEDO) > fitness (FITNESS NIVEAU/ FITNESS LEVEL)
In the middle row of the display the heart rate is shown while wearing the chest
belt. If the signal is received from the chest belt the heart symbol will flash.
To the right of the heart rate in percent of the maximum heart rate is shown. The
maximum heart rate is calculated by evaluating your age, weight and height.
Timer (TIMER)
The bottom row of the display will show the elapsed training time. The middle row
will show your heart rate and the heart rate in percent of the maximum heart rate.
The timer will start automatically when the chest belt starts measuring the heart
rate. The timer will continue counting the time if the feature mode of the watch is
changed.
Press SET to select the timer mode:
TIMER
total training time
training time in heart rate target zone
▲ training time with heart rate over target zone
▼ training time with heart rate below target zone
Press and hold SET to reset the training time.
Memory feature (SPEICHER/MEMORY)
The stored values are shown in the bottom row of the display.
- 62 -
HI (O) maximum heart rate during training
LO (U) minimum heart rate during training
AV (D) average heart rate during training
Press and hold SET to reset the stored values.
Target heart rate (ZONE)
The bottom row of the display will show the lower and upper limit value of the
target zone.
The selected training type is shown on the top row of the display.
L- U
user defined
1 Health (50-65% of maximum heart rate)
2 Fitness (65-80% of maximum heart rate)
3 Performance (80-95% of maximum heart rate)
Press and hold SET for 3 seconds to enter setting mode.
Select the training type by pressing SEL. If "U" is selected (user defined) the lower
and upper limits can be set. Press SET. The display will show the lower limit.
Set the value by pressing SEL and confirm your setting by pressing SET.
Set the upper limit in the same way.
Exit setting mode by pressing MODE.
Press and hold SEL to activate the heart rate alarm. When the heart rate alarm is
activated, the alarm symbol •)) will appear on and an alarm will sound when the
measured heart rate is not within the set zone "BEEP-BEEP...BEEP-BEEP...BEEP-
BEEP".
If the measured heart rate is at or above 99% of the maximum heart rate the max.
heart rate alarm will sound. "BEEP-BEEP-BEEP-BEEP-BEEP-BEEP". The max. heart
alarm is independant of the training zone and the heart rate alarm of the training
zone.