Florabest FTP 400 A1 - Manual (Page 54)

54
GB
ner that the stop is opened in
the flowing direction and closed
against the flowing direction.
To clean the paddle wheel
In the case of too severe precipitation in
the pump casing (12), the lower part of the
pumps must be disassembled as follows:
1. Loosen the screw (18a) on the
floor of the base (10) and re-
move the fixing cap (19) and
spring.
Caution:.the.screw.holds.
the.spring.together.with.
the.fixing.cap.(19).and.is.
therefore.live.
2. Take off the rotary disk (8).
3. Loosen the four screws (18 b-e)
on the base (10).
4. Take off the base (10).
5. Clean the paddle wheel, base
and rotary disk (8) with clear
water.
6. Screw the base (10) back on.
Ensure.that.the.base.and.
sealing.ring.(20).are.sitting.
correctly.
Any measures above and beyond these,
particularly opening the equipment, are
to be carried out by an electrician. In the
case of repairs, always contact our service
centre.
Storage
• Keep the device in a dry place, pro-
tected from frost and out of reach of
children.
Wind the mains cable around the
cable holder (1) on the back of
the pump body ( 1 2) (see chapter:
“Start Up“).
Waste Disposal and En-
vironmental Protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Electric appliances should not be
disposed of in the domestic gar-
bage.
Hand the tool in at a recycling centre. The
plastics and metal parts can be separated
and recycled. Ask your Service Center
about this.
Defective units returned to us will be dis-
posed of for free.
Spare Parts Order
When buying parts for the submersible
water pump, use the service address or fax
number given.
Please enter your machine type and the
item number of the part you are ordering
or its position on the exploded drawing.
Backflow stop .......... item No. 91045900
The backflow stop is subject to wear; its
replacement is not covered by guarantee.