Florabest Garden Hose Set - Manual (Page 15)

15 GB
®
Never leave the hose unsupervised – even if
the water flow is temporarily interrupted. Oth-
erwise injuries or property damage may occur.
Do not subject the hose to
frost. Otherwise property
damage may occur.
Ensure particles of dirt do not plug the connec-
tors or enter the hose. The fittings may otherwise
be damaged.
Do not aim the water jet at electrical equip-
ment.
Do not aim the water jet at persons or animals.
Assembly
you will need:
Cross-tip screwdriver (PH2)
Power drill (8 mm)
Important! Please refer to the operating instruc-
tions of your power drill.
Ensure that you do not damage any electrical cables,
gas or water pipes when you drill into the wall.
Installing the hose holder
Install the hose holder 7 is shown in Figure A.
Use the included screws 4 and rawlplugs 5 .
These are only suitable when mounting to brick,
concrete- or wooden walls. Please use suitable
screws and rawlplugs when mounting to other
materials. Consult your retailer for rawlplugs
and screws suitable for the respective wall.
Note: To prevent backflow, do not mount the
hose holder
7 higher than the tap, or install a
backflow preventer or stop cock between the
tap and hose
6 .
Use
Connecting
Connect the hose 6 as shown in Figure B.
Using the spray nozzle
Note: the spray nozzle 1 features ten different
spray patterns. The flow rate is variable.
Insert the spray nozzle 1 in the hose connec-
tor with water stop 3 (cf. Fig. C).
Move the trigger switch 1a to the back to start
water flow and for variable adjustment. (cf.
Fig. D).
Turn the wheel 1b to position „ “, to select or
adjust the spray pattern (cf. Fig. D).
Move the trigger switch 1a forward to stop the
water flow (cf. Fig. D).
Note: When removing the spray nozzle 1 with
the tap on, the hose connector with water stop 3
will interrupt the water flow.
Only use this option for interrupting the water flow
when connecting a different item to the hose, e.g. a
water sprinkler.
ATTENTION! Only use the options for interrupt-
ing the water flow described in this chapter to stop
the flow temporarily! To stop the water flow for a
longer period, close the tap.
Cleaning and Care
Use a slightly dampened, lint-free cloth for
cleaning and care.
Occasionally clean the connection to ensure
the hose connector sits tight.