Florabest FGS 3.6 A1 - Manual (Page 65)

65
GB
device.
3. To switch on, hold the switch
lock (2) depressed and operate
the on/off switch (8). Then re-
lease the switch lock.
The equipment runs at top
speed.
4. In order to switch off, let go of
the on/off switch (8).
After switching the unit
off, the blades take a short
time to stop moving. Let the
blades come to a complete
standstill. Do not touch the
moving blades and do not
try to stop them moving. In-
jury hazard!
Inserting/replacing the blade
Prior to each exchange of the
blades, make sure the device
is switched off and the safety
key and in order to avoid
danger and injuries!
Remove blade
1. Press the unlock buttons (10/13)
on the blade and remove the
entire blade.
Insert blade
2. Insert the grass shear blade (9)
or the shrub shear blade (12)
into the recess in the cutter head
(1).
3. Press the blade into the direction
of the cutter head (1). It locks
into place audibly.
General working instructions
While trimming, take care that there
are no objects such as wire, metal
parts, stones etc. come into contact
with the blades. This can lead to
cutting head damage. If the blades
become blocked by solid objects,
switch off the unit at once.
• Check the grass and bush trimmer
blades for obvious defects such as
loose, worn or damaged parts. Check
that the screws are seated firmly in the
blade block.
• Remove the power supply unit before
working with the equipment. Do not
use extension cables. The power sup-
ply unit is to be used only in enclosed
spaces.
• Only use sharp blades to achieve a
good cutting performance and pre-
serve the battery.
• Do not work the unit so hard that it
comes to a standstill.
• Pay attention to the instructions on unit
maintenance and cleaning.
Use as a grass trimmer
• Grass is best cut when dry and not too
long.
Adjusting the working angle
For a comfortable edge cut, the cutter head
(1) can be rotated by 90° to the right or left.
1. Operate the lever (3) and turn
the cutter head (1) into the de-
sired position.
2. Release the lever (3), the cutter
head locks into place.