Electrolux D77000GF - Manual (Page 33)

33
CLEANING THE DOOR(S)
To prevent damaging or weakening the
door glass panels avoid the use of the
following:
• Household detergents and bleaches
• Impregnated pads unsuitable for non-
stick saucepans
• Brillo/Ajax pads or steel wool pads
• Chemical oven pads or aerosols
• Rust removers
• Bath/Sink stain removers
CLEANING BETWEEN THE OUTER AND
INNER DOOR GLASS
The inner door glass is removable for cleaning.
TO REMOVE THE INNER GLASS
Open the oven door to gain access to the top of the
oven door.
To remove the top trim:-
Second Oven - Carefully pull the trim away from the
door and lift off.
Main Oven - Carefully push the trim towards the oven.
Remove the seal.
Hold the door glass securely in place with one hand
before sliding the glass out with the other hand.
Clean the outer and inner glass using hot soapy water
or Hob Brite cleaner may be used.
Do not use Hob
Brite on the Stainless Steel or painted finishes.
Ensure that all parts are well rinsed and thoroughly
dried before attempting to replace the outer door.
If the door glass panel becomes chipped or has
deep scratches the glass will be weakened and
must be replaced to prevent the possibility of
the panel shattering. Please contact your local
Service Force Centre who will be pleased to
advise further.
TO REPLACE THE INNER GLASS
To ensure the glass is properly located the text 'This
side up' should be facing towards you at the top edge
of the door and facing into the cavity.
Holding the glass with both hands, gently slide the
glass into the side trims of the oven door. Always
ensure that the glass is returned to the same side trim
it was removed from.
Replace the seal on the main oven door if removed.
To replace the trim, line up the clips on the underside
of the trim with the connectors at the top of the door.
Carefully slide the trim towards the door.
Ensure the trim is securely in place before closing the
oven door.
Do not attempt to use the oven without the
glass being in place.
Please note that the door
glass on your product may
differ in type and shape
from that shown in the
diagram.