Ultimate Speed UASB 12 A1 - Manual (Page 12)

9 UASB 12 A1
GB
Operating the seat cushion
♦ Plug the 12 V vehicle connector 4 into the cigarette lighter. The Power LED
5 illuminates.
♦ Turn the on/off switch 3 into position “I” to switch the seat cushion on.
♦ Turn the on/off switch 3 into position “0” to switch the seat cushion off .
♦ After using the seat cushion, disconnect the 12 V vehicle connector 4 from
the cigarette lighter.
NOTE
► The seat cushion also consumes power in standby mode and therefore
must be disconnected from the on-board power supply after use! Other-
wise, depending on the vehicle type, the battery will be discharged if the
motor is switched off .
Replacing the fuse
There is a fuse in the 12 V vehicle connector 4 for protecting the vehicle's on-
board power supply. If the product no longer works, check the fuse and replace
if necessary.
♦ Open the 12 V vehicle connector 4 by gently turning the fl uted screw
insert C anticlockwise (using pliers if necessary) and remove it.
♦ Now remove the connector tip B from the fuse A and remove the fuse A .
♦ Now place a new fuse of type F5AL 250 V into the 12 V vehicle connec-
tor
4 ,place the plug tip
B
onto the slightly protruding end of the fuse and
screw the previously removed screw insert C back in.
NOTE
► If the product still does not function, or the fuse blows again immediately,
there is a defect. Please then contact the Service Hotline (see chapter
Service).
A B C
IB_100113_UASB12A1_LB4.indb 9 20.05.14 17:27