Eagle Electronics IntelliMap 500C - Manual (Page 21)

15
See the diagrams on the following page for general wiring connections.
Read your other product’s owner’s manual for more wiring information.
NMEA Wiring
To exchange NMEA data, the IntelliMap 500C has one NMEA 0183
version 2.0 communication port. Com port one (Com-1) can be used to
receive NMEA format GPS data. The com port can also transmit NMEA
format GPS data to another device.
The data cable contains three wires. Com-1 uses the yellow wire to
transmit, the orange wire to receive and the shield wire for signal
ground.
Com-1 wiring to receive NMEA position information
from some other GPS receiver.
Com-1 wiring to transmit NMEA position information
to another NMEA-compatible device.
Mounting the Unit: Bracket, In-Dash or Portable
You can install the IntelliMap 500C on the top of a dash with the sup-
plied gimbal bracket. It can also be installed in the dash or mounted on
a portable power supply.
If you use the supplied bracket, you may be interested in an optional
R-A-M

bracket mounting system. This converts the unit's gimbal bracket
to a swivel mount, which can be used on the dash or overhead mounting
positions. R-A-M offers permanent mounts and temporary mounts suitable
for many vehicle types. See your Eagle dealer or visit the LEI web site
(www.lei-extras.com) for the latest options; accessory ordering information
is on the inside back cover of this manual. For a complete look at the many
mounting options, visit the RAM web site at www.ram-mount.com.
Ground
To Other
Device
Orange (Receive) NMEA Transmit
Shield (Ground) Ground
Com-1 to
IntelliMap 500C
To Other
GPS Receiver
Com-1 to
IntelliMap 500C
Yellow (Transmit) NMEA Receive
Shield (Ground)