Eagle Electronics IntelliMap 500C - Manual (Page 42)

36
Basic GPS Quick Reference
Start outdoors, with a clear view of the open sky. As you practice, try
navigating to a location at least a few blocks away. While you're learning,
navigation in too small an area will constantly trigger arrival alarms.
1. Connect the unit to electric power and the antenna module. Make sure
the MMC is in. (See complete installation details beginning on page 11.)
2. To turn on the unit, press and release PWR key.
3. Opening screen displays map of North America at 4,000 mile zoom
range. Rotate through the three main Page screens (Map Page, Satel-
lite Status Page and Navigation Page) by pressing
PAGES |
← or → to
select Page Name| EXIT . Switch Pages to display Satellite Status Page.
4. Wait while unit locates satellites and calculates current position. Process
is visible on Satellite Page. This takes about a minutes or less under clear
sky conditions (unobstructed by terrain or structures.) When position is
acquired, unit sounds a tone and displays a "position acquired" message.
The present position arrow and information shown in data boxes or as
overlay data will stop flashing.
5. With position acquired, press PAGES key to display Map Page, which
shows a bird's eye view of the earth. You can move around the map by:
Zoom in closer to see greater detail: press
ZIN (zoom in key.)
Zoom out to see more area, less detail: press
ZOUT (zoom out key.)
Scroll map north, south, east or west using arrow keys ↑ ↓ → ← .
To stop scrolling and return to current position on map, press EXIT key.
6. Set a waypoint (Wpt 001) at your current position so you can navigate
back here: press
WPT | WPT . Waypoint symbol and "001" appears.
7. Zoom/scroll map to find a nearby object or location to go to. Use ar-
row keys to center cursor cross-hair over the map object or location.
8. Navigate to the selected destination: press MENU | ENT | EXIT . Follow red
course line on Map Page or compass bearing arrow on Navigation Page.
9. At destination, Arrival Alarm goes off; to clear it, press EXIT . Cancel
navigation: press MENU | MENU |
↓ to
C ANCEL N AVIGATION
| ENT |
← to Y
ES
| ENT .
10. Return to Wpt 1 by Navigate To Waypoint or Backtrack Trail.
To
Waypoint: press
WPT | ENT | ENT . Use
↑ or ↓ to select Wpt 001, press
ENT | ENT ; follow navigation displays.
Trail: press
MENU | MENU |
↓ to
M Y
T RAILS
| ENT . Press
↓ to Trail 1|
ENT |
↓ to
D ELETE T RAIL
|
→ to
N AVIGATE
| ENT .
Press
→ to
R EVERSE R OUTE
| ENT |
← to
N AVIGATE R OUTE
| ENT . (If arrival
alarm sounds, press EXIT .) Follow navigation displays.
11. Back home, Arrival Alarm goes off; press EXIT . Cancel navigation:
press MENU | MENU |
↓ to
C ANCEL N AVIGATION
| ENT |
← to Y
ES
| ENT .
12. To turn off the unit, press and hold PWR key for three seconds.