Livarno TL1710 - Manual (Page 10)

Energy-saving table lamp TL1710
English - 8
Model A
š Remove both screws (1) with the protective sleeve (2) and the
counterprofile (3) from the U-bolt on the lamp base.
š Put one of the screws (1) through one of the protective sleeves (2) and
guide both from the outside through one of the two holes in the lampshade.
š Hold the counterprofile (3) from the inside in front of the hole and guide the
screw (1) through.
š Then turn the screw (1) in the corresponding hole on the U-bolt of the lamp.
š Repeat the process with the second screw and the second protective
sleeve.
š Screw the supplied bulb into the bulb socket (5).
1 Screw
2 Protective
sleeve
3 Counterprofile
4
Position of
lampshade
5 Socket
Figure: Lamp type A, Detailed figure of the screw joint