Livarno Z29538 - Manual (Page 6)

6 GB
General Safety Instructions / Bringing into use
Battery Safety
Instructions
WARNING! DANGER TO LIFE! Keep
batteries out of the reach of children. Do not
leave batteries lying around. There is a risk of
children or animals swallowing them. Consult a
doctor immediately if a battery is swallowed.
J  EXPLOSION HAZARD! Never
recharge nonrechargeable batteries,
short-circuit and / or open batteries.
This can cause them to overheat, burn or burst.
Never throw batteries into fire or water. The
batteries may explode.
J  Remove spent batteries from the product
immediately. Otherwise there is an increased
risk of leakage.
J  Always replace all batteries at the same time
and only use batteries of the same type.
J  Do not use different types of batteries or mix
used and new batteries together.
J  Check regularly that the batteries are not leaking.
J  Leaked or damaged batteries can cause chemi-
cal burns if they come into contact with the skin;
in such cases you must wear suitable protective
gloves.
J  Remove the batteries from the product if it is not
in use for any length of time.
J  Make sure that the polarity is correct when you
insert the batteries. This is indicated in the bat-
tery compartment. The batteries can otherwise
explode.
J  Remove used batteries from the device. Very old
or used batteries may leak. The chemical fluid
can damage the product.
Q Bringing into use
Q 
Inserting/replacing
the batteries
j  Turn the battery compartment cover 3 anti-
clockwise and take it off the battery compart-
ment
2 (see Fig. A).
j  Insert the (new) batteries into the battery
compartment
2 .
Note: Make sure you fit the batteries the right
way round (polarity). The correct polarity is
shown inside the battery compartment
2 .
j  Put the battery compartment cover 3 back in
place on the battery compartment 2 and turn
it clockwise to tighten it (see Fig. B).
Q Installing the light
j  Pull off the protective film from the self-adhesive
pad
4 of the battery compartment cover 3
(see Fig. C).
j  Attach the light in the desired location.
NOTE: The substrate should be dry, smooth
and free of dust and grease.