Livarno LLR 58 A1 - Manual (Page 13)

13
Safety instructions
Before first using this device please read
the following instructions carefully and take
note of the safety warnings, even if you are
familiar with using electronic devices.
Please keep this manual safe for future
reference. Please ensure that, if you resell
or pass on this device, you also include
these instructions.
Electrical devices do not belong in
children's hands. Never allow children
to use electrical devices
unsupervised. Children cannot always
recognise possible hazards. Batteries
and small parts may cause choking
resulting in death or serious injury.
Keep packaging away from children
as it is a suffocation risk.
If you notice any smoke, unusual
noises or strange smells, switch off
the device immediately and remove
the plug from the wall outlet. Do not
inhale any smoke originating from a
device fire. In these cases the device
should no longer be used and should
be inspected by authorized service
personnel. If you have nonetheless
inhaled smoke, consult a physician.
Breathing in smoke can be harmful.
Ensure that you have at least one
other lamp available. The fluorescent
tube should not be your only source of
light so that there are other sources of
light available to fall back on in
dangerous situations.
Do not damage the housing or the
mains cable. Never replace a faulty
cable; instead take the light out of
service. When the housing or cable is
damaged, you are in danger of
receiving a life-threatening electric
shock.
The light does not contain any parts
that require servicing. Never open the
housing of the light. Inside the casing
there is a glass tube. Ensure that the
light is not subjected to excessive
vibrations. If the glass tube breaks,
the light is unrepairable and must be
disposed of. There is a risk of injury if
the glass body is broken!
Do not hang any objects on the light.
The casing is not designed to carry
loads. Do not allow any flammable
materials next to or behind the light.
This can damage the lamp and there
is risk of fire.
Intended use
This light is not intended for commercial
use. Install this light only in enclosed
rooms. Assembly must be carried out
properly. The light can be fixed to a wall
using the supplied assembly clips. The
supplied base permits the light to be used
in a standing position.
The light is a fluorescent tube and not
designed to be dimmed.
This device meets all relevant norms and
standards in conjunction with CE
conformity. Compliance with these norms
is no longer guaranteed if the device is
altered in ways not sanctioned by the
manufacturer.
Description
The parts shown in the illustration are as
follows:
[1] Assembly
clips (2 pieces)
[2] Fixing screws, 32 mm for assembly
clips (2 pieces)
[3] Rawlplugs (2 pieces)
[4] Fixing screws, 21 mm for light stand
(2 pieces)