Electrolux WAVE-TOUCH 318205319 - Manual (Page 16)

16
Timers
Getting Started
Setting clock at power up
You will be prompted to enter the time of day in the
event of a power failure or when you fi rst provide
electric power to your appliance.
• When your appliance is fi rst powered up, 12:00
will fl ash in the display.
• Enter the time of day using the numeric key pads
and press START to set.
If an invalid time of day is entered, the control will
triple beep. Re-enter a valid time of day and press
START. If CANCEL is pressed your clock will start
with the time set for 12:00.
Select the user pref key to modify the time of day
during other situations such as day light savings.
See example below to set the timer for 5 minutes:
Sleep mode
Your control will remain in a sleep mode when not
in use. Only the clock will display during this mode.
You will need to wake the control to begin any
function.
Awake mode
To awake the control touch within the display panel.
If the control panel is not touched again within 2
minutes, the control will return to the sleep mode.
To start cooking you must select either the micro
oven or the lower oven. User preferences will be
available during the awake mode as well as timers,
oven light and the control lock.
NOTE
The timer(s) will not affect the cooking process.
Sleep mode Fig.1
The two timers provided with the oven control
serve as extra reminders in the kitchen. When a
timer reaches less than 1 hour, the display will start
to count down in minutes and seconds. When the
time runs out the active timer will beep, “0:00” will
fl ash.
The following time settings apply to the timers:
• Min. time: 1 minute
• Max. time: 11 hours 59 minutes
To cancel after setting the timer, press the TIMER
key again.
Awake mode Fig.2
Wave-Touch™ display modes
Example
Step Press
1. Press TIMER
2. Enter 5 minutes
3. Press TIMER