Livarno Z31285A-BS Z31285B-BS Z31285C-BS - Manual (Page 5)

5 GB/IE
Avoid the danger of
death from electric shock!
J Before use, ensure that the mains voltage
available is the same as the required operating
voltage for the device (230 V~).
J Before connecting the device to the mains you
should always check the device and the mains
lead for any damage. A damaged device rep-
resents the danger of death from electric shock.
J Do not use the device if you find any damage.
J This product’s external flexible tube is not replace-
able. Hence, if it becomes damaged you must
dispose of the entire product.
J Set the lamp in a stable, clean and even place.
J Please consult a specialist electrician if you dis-
cover any damage or problems with the device,
or for the performance of repairs to the device.
J Never open any of the electrical equipment or
insert any objects into it. Such interventions rep-
resent the danger of death from electric shock.
J It is essential that the device does not come
into contact with water or other liquids.
J Never touch the mains plug with damp or wet
hands.
J Protect the mains lead against sharp edges,
mechanical stresses and hot surfaces.
J Never use the device in the immediate vicinity
of a bathtub, shower or swimming pool.
J If the lamp is not to be used for an extended
period (e.g. during your holidays), pull the
mains plug out of the mains socket.
To avoid danger of fire
and injury!
J DANGER OF INJURY! Check
any bulb for damage immediately
after unpacking. Do not fit a defective
bulb into the lamp.
J DANGER OF BURNS! Ensure the
lamp has been switched off and al-
lowed to cool before you touch it.
In this way you will avoid the danger of burns.
Light bulbs develop a great deal of heat.
J Replace a defective bulb immediately. Before
replacing the bulb always remove the mains
plug from the mains socket.
J Allow the lamp to cool for at least 15 minutes
before replacing a defective bulb.
J
0.5 m
DANGER OF FIRE! Always ensure
that there is at least 0.5 m clear dis-
tance between the lamp and other
items of furniture or furnishings.
J Do not allow any objects to cover the lamp.
Fire can result from the development of too
much heat.
J Position the lamp so that it is protected from
moisture and dirt.
J Never leave the lamp operating unattended.
J Only use 230 Volt Eco halogen light bulbs
with an E 27 base and a maximum output of
42 watts.
J This lamp is only intended for use
indoors.
Q Bringing into use
Q
Assembly
Insert the lower articulated arm 3b into the
hole in the base 8 .
j Fasten the lower articulated arm 3b in place
with the base screw (approx. 10 mm) 7 .
j Place the lamp-shade 12 onto the top of the
lamp 1 . Insert the bulb socket ring 11 and
screw a bulb 10 into the lamp fitting.
j Tighten the screw (approx. 18 mm) 9 with a
nut at the hole on the upper articulated arm
(see Fig. A). Check that it sits correctly.
WARNING! RISK TO LIFE FROM ELEC-
TRIC SHOCK! Before you clean the bulb 10 , pull
the mains plug out 5 of the mains socket.
Note: use a clean, fluff-free cloth when you are
replacing a bulb
10 .