Safety / bringing into use, Bringing into use – Livarno Z31303A-BS Z31303B-BS User Manual
Page 7
7
GB/IE/CY
Safety / Bringing into use
required operating voltage for the
device (230-240 V ~).
J
Before connecting the device to the
mains you should always check the
device and the mains lead for any
damage. A damaged device repre-
sents the danger of death from
electric shock.
J
Do not use the device if you find
any damage.
J
Please consult a specialist electrician
if you discover any damage or prob-
lems with the device, or for the per-
formance of repairs to the device.
J
Never open any of the electrical
equipment or insert any objects into
it. Such interventions represent the
danger of death from electric shock.
J
It is essential that the device does
not come into contact with water or
other liquids.
J
Protect the power supply cable
4
from sharp edges, mechanical
strain and hot surfaces.
J
Never use the device in the immedi-
ate vicinity of a bathtub, shower or
swimming pool.
J
Do not look directly into the light or
its reflection. Do not aim the light
directly at people. This could pro-
duce glare, leading to accidents.
J
If direct or reflected light strikes your
eyes, close them and move your
head immediately out of the light.
J
Operate the lamp only with sup-
plied mains adapter (LPS03-120-
0100-3W). Please note that any
damage caused through the use of
a different adapter is excluded from
the warranty.
J
Never touch the mains adapter
6
with moist or wet hands.
J
If the lamp is not to be used for an
extended period, e.g. while you
are away on holiday, then the
mains adapter
6
must be pulled
out of the mains socket.
J
The bulb becomes hot during oper-
ation. Allow the lamp and bulb to
cool before you touch them.
J
The LEDs cannot be replaced.
Q
Bringing into use
j
Never direct the LED light beam on
to reflective surfaces or at people
or animals. Failure to observe this
advice may result in eye injury
and/ or loss of sight to people or
animals. Even a weak LED light
beam can cause eye damage.
j
Attach the lamp in the desired posi-
tion by means of the clamp
2
.
77618A_B GB_IE_CY.indd 7
8/8/2012 5:44:19 PM