Silvercrest Heated Mattress Pad - Manual (Page 29)

33 GB/MT
Safety system / Preparing for use / Use
If the safety system switches the electric underblanket
off automatically due to a fault, then the function in-
dicator
2 on the control unit 1 ceases to illuminate,
even if the electric underblanket is switched on.
J Please note that, for safety reasons, the electric
underblanket must not be used in the event of a
fault and must be sent to the service centre ad-
dress given below.
Q Preparing for use
Q Placing the electric
underblanket
j Starting at the foot end, spread out the electric
underblanket over the mattress. The plug-in
connector
5 on the electric underblanket
should be towards the head end.
j Then place the bottom sheet as usual over the
electric underblanket, so that the electric under-
blanket lies between the mattress and the bottom
sheet.
j Ensure that the electric underblanket is com-
pletely flat and that it does not become drawn
together or folded during use.
j Switch the electric underblanket on approximately
30 minutes before going to bed and cover it
with the top sheet and other bedding. By doing
this you will keep all the heat in.
Q Switching on / off /
Selecting the temperature
j First connect the control unit 1 to the electric
underblanket by plugging the two parts of the
plug-in connector
5 together (see Fig. B).
Switching on:
j Using the temperature setting switch 3 on the
control unit 1 , set the temperature to setting
1, 2, 3, 4, 5 or 6 to switch on the electric under-
blanket. The function indicator
2 illuminates.
Switching off:
j Using the temperature setting switch 3 on the
control unit 1 , set the temperature to setting 0
to switch off the electric underblanket. The function
indicator
2 ceases to illuminate.
Selecting the temperature:
j This electric underblanket has a rapid heat-up
feature.
j Set the control unit to the highest temperature
setting (setting 6). This will cause the electric
underblanket to warm up quickly.
j For use over several hours, set the control unit 1
to the lowest temperature setting (setting 1).
Q Use
Q Setting the temperature
j Using the temperature setting switch 3 on the
control unit 1 , set the temperature to the desired
temperature setting (see Fig. A).
Setting 0: Off
Setting 1: Minimum heat
Settings 2 - 5: Customised heat
Setting 6: Maximum heat
The foot zone is the warmest part of the electric
underblanket.
Note: This electric underblanket has overheating
protection.
After a period of approx. 3 hours at temperature
settings 5 or 6, the electric underblanket automatically
switches down to setting 4.
Q Selecting the automatic
switch-off time
j Using the switch-off time setting switch 4 on
the control unit 1 , set the desired switch-off
time. The switch-off time can be set to 1, 3, 6
or 12 hours.
64704_silv_Waermeunterbett_Content_LB5.indd 33 06.05.11 14:02