Enterasys Networks C2K122-24 - Manual (Page 36)

Installing the Switch on a Flat Surface
3-6 Hardware Installation
Figure 3-2 Chassis Bottom, Rubber Feet Placement
4. Remove the protective strip from the back of one rubber foot and position it on a
marked location and press firmly into place. Repeat this procedure to install the
remaining three rubber feet in the other three locations.
5. After installing the rubber feet, return the switch to its upright position.
6. Proceed to “ Guidelines for Installation ” on page 3‐6. For a rackmount installation,
proceed to “ Rack Mounting the Switch ” on page 3‐7.
Guidelines for Installation
Locate the switch within 152 cm (5 ft) of its power source and on a surface as shown in
Figure 3‐3 . If an optional redundant power system is going to be installed and connected
to the 14‐pin Redundant Power Supply input connector on the rear of the switch, refer to
the installation guide shipped with the redundant power system.
1 Bottom of chassis as seen when chassis is
resting on its back
3 Rubber feet with adhesive backing
(four)
2 Locations to install the rubber feet (four locations)
Note: If a number of switches are being installed in a stack, repeat steps 1 through 4 to
install the rubber feet on each switch before continuing with the installation.
А Б
В В
В В