Enterasys Networks C2K122-24 - Manual (Page 58)

Using LANVIEW
4-2 Troubleshooting
Using LANVIEW
The switch supports the Enterasys Networks built‐in LANVIEW LED visual diagnostic
and status monitoring system. The location of each C2K122‐24 LANVIEW LED is shown
in
Figure 4‐1 . The LEDs enable you to quickly observe network status for diagnosing
switch and network problems.
Figure 4-1 C2K122-24 LANVIEW LEDs
Table 4‐2 describes the LED indications and provides recommended actions as
appropriate.
1 CPU LED 6 Link/Activity LED for 10/100/1000 Mbps,
2 STACK DOWN LED port 1 of the 24 RJ45 ports
3 STACK UP LED 7 Link/Activity LEDs for 10-Gbps XFP ports,
4 RPS LED for redundant power-source status 25 and 26
5 Manager LED
Note: The terms flashing, blinking, and solid used in Table 4-2 indicate the following:
Flashing: LED is flashing randomly.
Blinking: LED is flashing at a steady rate (approximately 50% on, 50% off).
Solid: LED is on steady and not pulsing.
Console
1
2
23
24
25 26
CPU
UP
RPS
MGR
DOWN
13
14
11
12
25 26 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 C2K122-24
TX RX TX RX
1
2
CPU
UP
RPS
DOWN А Б
В
Г
Д
Е Ж
MGR