Enterasys Networks C2K122-24 - Manual (Page 38)

Rack Mounting the Switch
3-8 Hardware Installation
Guidelines for Rackmount Installation
The installation site must be within reach of the network cabling and meet the
requirements listed below:
• Appropriate grounded power receptacles must be located within 152 cm (5 ft) of the
location.
• A temperature of between 5°C (41°F) and 40°C (104°F) must be maintained at the
installation site with fluctuations of less than 10°C (18°F) per hour.
Attaching Brackets and Installing in Rack
Proceed as follows to install the switch into a 19‐inch rack:
1. Attach the rackmount brackets to the switch, as shown in Figure 3‐4 , using the eight
M3 x 6 mm flathead screws shipped with the switch.
Figure 3-4 Attaching the Rackmount Brackets
2. With the mounting brackets attached, position the switch between the vertical frame
members of the 19‐inch rack as shown in
Figure 3‐5 . Then fasten the switch securely
to the frame using four mounting screws (user supplied).
Note: To ensure proper ventilation and prevent overheating, leave a minimum clearance
space of 5.1 cm (2.0 in.) at the left, right, and rear of the switch.
Warning: Before rack-mounting the device, ensure that the rack can support it without
compromising stability. Otherwise, personal injury and/or equipment damage may result.
Advertencia: Antes de montar el equipo en el rack, asegurarse que el rack puede
soportar su peso sin comprometer su propia estabilidad, de otra forma, daño personal o
del equipo puede ocurrir.
Warnhinweis: Überzeugen Sie sich vor dem Einbau des Gerätes in das Rack von dessen
Stabilität, ansonsten könnten Personenschäden oder Schäden am Gerät die Folge sein.
1 Rackmount brackets 2 M3 x 6 mm flathead screws
Б А Б А
Console
1
2
23
24
25 26
CPU
UP RPS
MGR
DOWN
13
14
11
12
25 26 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 C2K122-24
TX RX TX RX