Silvercrest Energy Monitor - Manual (Page 21)

23 GB
Operation
Q  Set electricity rate 1 and 2
note: the price per kWh is set to 0 on delivery.
note: you can set two different electricity rates (e.g. daytime
and night-time rate) for the power cost meter. In order to use
this function, you must set the starting times for electricity rate
1 and 2.
IMPOrTAnT! Electricity rate 1 is automatically the rate
that was programmed first.
Tip! You can obtain details of the current price per kWh
from your electricity provider.
note: please make sure that the top third of the LC display
1 shows the standard display (see “Display current”).
Proceed as follows:
1. Press the “DOWN” button 4 until the price per kWh
symbol 19 (“PRICE KWh”) appears in the centre of the
LC display 1 .
2. Press the “UP” button 5 so that four digits appear in the
bottom third of the LC display 1 . The symbol 15
also appears.
3. Now press the “SET” button 2 . The first digit starts to
flash.
4. Press the “UP” 5 or “DOWN” button 4 to set the
units digit before the decimal point of the current price
56861_Energiekostenmessgeraet_Content_GB-PL-CZ-SK.indd 23 26.11.10 10:12