Silvercrest SZW 400 A1 - Manual (Page 12)

10
6.3 Thermal cut-out
The appliance has a thermal cut-out. If the
temperature rises too high and there is a risk
of damage, the appliance switches off
automatically.
In this case unplug the mains plug
immediately and have the appliance
inspected. The contact data can be found in
“Service Centre” on page 13.
7. Cleaning
Warning! To avoid the danger of
an electric shock, injury or damage:
– Remove the plug from the mains
socket before starting to clean
the appliance.
– Allow the appliance to cool
down before cleaning.
– Never immerse the bottom
section 9 in water, and protect it
from splashes and drops of
water.
Caution! Never use abrasive, corrosive or
caustic cleaning materials. These could
damage the appliance.
7.1 Dismantling the appliance
1. Remove the plug from the mains socket.
2. Take off the splash guard 1.
3. Pull the carameliser 2 upwards and off.
4. Turn the candyfloss bowl 6 clockwise
and lift it up and off.
7.2 Cleaning the bottom section
1. Clean the bottom section 9 with a damp
cloth. You could also use a little
washing-up liquid.
2. Wipe off with clean water.
3. Do not use the machine again until it is
fully dry.
7.3 Cleaning the carameliser
Note: The carameliser 2 must be cleaned
carefully after each use. If the carameliser 2
is dirty it will not work properly.
1. Clean the carameliser 2 by hand in
warm water.
Caution! The carameliser 2 is not
dishwasher safe.
2. For stubborn encrustations leave it to
soak in warm water for about
20 30 minutes. You could add a few
drops of mild washing-up liquid.
Note: Water will accumulate in the
edges of the carameliser 2 during this
process. This must be removed before
the appliance can be used again.
3. Carefully shake out any water from the
carameliser 2.
4. Let the carameliser 2 dry thoroughly
before using the appliance again.
RP75819 ZuckerWG LB4 Seite 10 Dienstag, 24. Juli 2012 9:44 09