How to assemble attach handle, Insert battery – Eureka 570 User Manual

Page 6

Advertising
background image

HOW TO ASSEMBLE

Attach Handle

1. Locate the handle and body.

2. Line the handle up with the hole in the

top of the body. Flat side of handle and
loop forward.

3. Push handle down into body while

pressing button on back of the body.
Handle will click into place.

4. There are two handle positions available.

Handle all the way up and handle all the
way down.

5. Button needs to be depressed to raise

and lower the handle.

Insert Battery

Hold battery so thumb is positioned on thumb
grip button and push completely into body
until battery clicks into place.

Button

6

Loop

Handle

Body

Thumb Grip
Button

To Remove Battery

Grasp end of battery using thumb grip and pull
out of body.

NOTE: Charge the batteries for 14-16

hours before initial use. A cleaner
may lose charge in shipment. The
charger body will become warm,
however, this is not a cause for
concern.

NOTE: For extended battery run time and

to prevent long fringe of some area
rugs from wrapping around brush
roll, place switch in floors (brush
roll off) position.

NOTE: Cleaner will not run when charger

is connected and battery is in the
unit.

CAUTION: To avoid risk of fire, use only

genuine Eureka replacement
battery packs.

Thumb

Grip Button

Body

Battery

Advertising