Eureka 570 - Manual (Page 9)

HOW TO MAINTAIN
(continued)
Brush Roll
NOTE: Turn off switch and remove battery before
inspecting brush roll.
Long hair, thread, string, etc. can wrap around the revolving
brush roll and result in reduced performance.
To check brush roll for debris turn cleaner nozzle over and
inspect for wrapped matter. Use scissors to cut debris from
brush roll. When brush roll is clean reinstall the battery and
resume operation.
Brush Roll
How to Check for Blockages
NOTE: Turn off switch and remove battery before checking for blockages.
If suction performance diminishes and battery is still strong, check for blockages in
suction path.
1. Remove dust cup and set aside.
Remove battery and set aside.
2. Inspect for blockages inside hole area
at base of body opening. Use tool or
coat hanger to remove blockage.
Hole
9
4. Flip vacuum over and inspect dir t
channel in brush roll area. Open access
door by pulling back on access door
latch and lifting up, check for blockage.
Remove any blockages with tool or coat
hanger.
Brush Roll
Area
3. Reinstall dust cup.
Access
Door Latch