How to use power switch, Nozzle with edge kleener, How to maintain – Eureka 570 User Manual

Page 7: Empty dust cup, Dual uses

Advertising
background image

HOW TO USE

Power Switch

The power switch has three positions. Off, Floor (hard surface cleaning) and Carpet.

Nozzle with Edge Kleener

®

Airflow under the nozzle automatically directs
suction to the edges and corners for maximum
full width cleaning.

Experiment with your hard floor surfaces,
sometimes it is best to have brush roll
turning. (Switch in the

carpet

position).

HOW TO MAINTAIN

The instructions given in this booklet serve as a guide to routine maintenance. Keep the
cleaner operating at top efficiency. Empty the dust cup after each use.

Empty Dust Cup

1. Pull dust cup latch

up.

2. Swing dust cup out

from body and up
off the dust cup
hook on the body.

4. To replace dust cup, fit

dust cup down onto
hook.

5. Swing down and push

gently into body until
dust cup clicks into
place.

3. Leaving dust cup filter in

the dust cup, shake
contents of dust cup into
a waste container. If
picking up lots of carpet
fuzz or pet hair, remove
filter. (To clean dust cup
filter refer to dust cup
filter section.)

Dual Uses

Push the handle button to release lock.
The handle will slide freely until it finds
one of the two available handle
positions. It automatically locks in either
of these two positions.

With the handle collapsed, the unit is
great for stairs and compact storage.
With the handle extended, the unit is
great for floor cleaning.

Power
Switch

Latch

Hook

7

Stair
Cleaning
Handle

Advertising