Qlima D512 - Manual (Page 97)

2 Press the -button to switch the device on, the louver will open (D516 - D 520). When
in auto mode, the adjustment button is used to set the desired humidity level. The
hydrostat is adjustable from 40% to 80%.
The value increases by 5% each time you press the button. The display indicates the
set humidity (SET HUMIDITY) and also the relative humidity (ROOM HUMIDITY).
D516 - D 520
The device will show a blue indicating light around the control panel to show to the user
that the device is working.
The blue indicating light can be switched “off” or “on” by pressing the and at the
same time. This will not influence the dehumidification performance of the device.
3 Ensure that the water container has been positioned correctly. If the -light switches
on when you use the device for the first time, remove the water container from the
device and replace it in the correct position.
When in auto mode, the device starts to dehumidify when the relative humidity in the
room is higher than the set value.
The device switches off automatically when the set value is reached (fan will continue in
low speed), and restarts when the humidity in the room rises again.
G
NOTE!
• For extra protection of the compressor the dehumidifier is programmed such
that the compressor can only restart when more than 3 minutes have past
since compressor has switched off.
• To optimise the dehumidification efficiency and to prevent possible
decolouring: always place dehumidifier away from direct sunlight.
4 The timer function enables you to switch the device on/off after a certain time. The
operating time can be set between 1 and 24 hours with the -button. Every time you
press the button, the running time is extended by 1 hour. This will be shown on the
display. When the pre-set time has elapsed, the device will switch off.
When setting the timer when device is “ON”: the device will switch “OFF” once the pre-set
time has elapsed.
When setting the timer when device is “OFF”: the device will switch “ON” once the pre-set
time has elapsed.
(timer setting is not memorised in case of power failure)
5 Press the -button to turn the device off. The louver will close (D 516 - D 520).
CHANGING THE MODE.
Use the -button to toggle between
- continuous dehumidifying mode
- automatic mode
- fan speed mode
When toggled to continuous dehumidification mode the -symbol will blink. Press the
4
97