RISCO Group RK-308 - Manual (Page 2)

2
Introduction
The MINI is a passive infrared detector that is simple to install with
an integrated wall bracket.
Preliminary Considerations
Choose the mounting location after careful consideration of the
protected area. The MINI should be located so that an intruder will
cross the infrared beam pattern at an angle closest to perpendicular.
Do not mount the unit in direct sunlight or near heat sources.
Front Cover Removal
Remove the front cover by twisting a flat screwdriver in the slot
between the cover and the base at the bottom of the MINI.
Mounting Procedure
Remove the desired knockouts in the MINI base for the mounting
screws and for cable entry. Insert the cable and attach the base to the
wall or corner.
Terminal Connections
Wire the cable to the terminal block at the bottom of the PC Board as
follows:
Terminal Purpose
12VDC Power supply inputs
ALARM N.C dry contacts
TAMPER N.C dry contacts
Seal the hole used for cable entry with suitable sealant.