RISCO Group WL RWS401 - Manual (Page 7)

Wireless Sounder Instructions
7
Strobe Arm Squawk
The time that strobe blinking will continue when set is performed (Default: 05)
NOTE:
If the sounder’s squawk strobe is defined as NO (Refer to the Allocation section) this parameter will be
ignored.
Adjusting the Volume
Defines the sounder sound volume for the following system modes:
 Exit / Entry: The sound produced during Exit/Entry time (Default: 0)
 Alarm: The sound produced during alarm (Default: 9)
 Squawk: The sound produced during squawk sounds (Default: 9)
The sound volume range is between 0 (silent) to 9 (maximum volume).
Muting Tamper
This feature disables a tamper alarm from the sounder and it is recommended to be
used when replacing the sounder's batteries.
NOTES:
1. An ongoing tamper alarm will not be disabled.
2.
WisDom: This feature is controlled under the Engineer Menu (Quick key [9][2][5]). Tamper alarm
will be disabled during the current installation programming period.
3.
Agility: Grandmaster Code/User Menu > Activities > Advanced > Service Mode (Agility 3 only)
The tamper alarm will be disabled for the time programmed in the Mode Service timer.
4.
LightSYS (V2.40 and above): Grandmaster Code/User Menu > Activities > Advanced > Service
Mode
The tamper alarm will be disabled for the time programmed in the Mode Service timer.
Setting Supervision Time
Specifies how often the system generates a supervision request to the sounder.
If any of the sounders does not respond to the request at least once during the
receiver supervision time, the system will regard the accessory as lost.
NOTE:
The receiver supervision time should be higher than the sounder supervision time in order to
eliminate false lost event.
Range: 00-255 minutes
Default: 58 minutes
NOTE:
WisDom: Engineer menu: 1) System > 1) Timers > 9) Accessory supervision time
Agility: Engineer menu: 1) System > 1) Timers > TX supervision
LightSYS (V2.40 and above): Engineer menu: 1) System > 1) Timers > 6) Wireless > 3) TX
supervision.