RISCO Group ProSYS Version 8.xx - Manual (Page 3)

ProSYS Version 8.xx - Supplementary Instructions 3
Introduction
This document describes the following improvements and changes in the ProSYS version 8.XX
due to market requirements and quality improvements:
x ProSYS Touchscreen keypad
x Fast PSTN modem – 2400 BPS
x iWISE BUS detectors (Grade 2, Grade 3)
x BUS detector naming conventions
x Proximity Anti-Mask setting for WatchOUT DT Version B
x Output activation using a Proximity Tag
x PCB labeling modification
Please follow the instructions below and refer to the indicated documents for a detailed
description of all the software changes.
New BUS Accessories
The information in this section describes new accessories that have been added to the ProSYS
BUS and modifications that have been implemented in parameters under the Engineer
programming menu.
Touchscreen Keypad
There is a new 7" Touchscreen keypad with a slim and contemporary design. The Touchscreen
Keypad is compatible with any ProSYS version and is available with or without a proximity
reader.
Adding/deleting the Touchscreen keypad is identical to the procedure for the adding/deleting of
current ProSYS keypads.
BUS Zone Expanders
There are new wired BUS Zone Expanders that enable to expand the number of BUS zone
detectors in the ProSYS.
When adding/deleting a BUS Zone Expander there are four new types to choose from:
x BZE08 (8 BUS zone expander)
x BZE16 (16 BUS zone expander)
x BZE24 (24 BUS zone expander)
x BZE32 (32 BUS zone expander)
For detailed information refer to the instructions supplied with the product.
Fast PSTN Modem - 2400 BPS
The Fast PSTN Modem enables PSTN communication at 2400 Bps between a remote PC and
the ProSYS security panel when programming the system using the Upload/Download software.
Important:
Communication with the fast modem is supported by ProSYS Version 8 and above and by
Upload/Download software version 3.2.4.8 and above.
Adding the Fast PSTN Modem to ProSYS:
1. Access the Engineer menu and select [7] Install > [1] Add Delete Module > [9] More.. > [6]
XMODEM.
Set the Type field to XModem.