List – Remote Processing CAMBASIC User Manual
Page 105
Comm ands - 72
LIST
Command
SYNTAX:
LIST [line [– [line]]]
LIST #n, [line [– [line]]]
LIST!
PURPOSE:
To list a part or all of the program curr ently in memory.
REMARK S:
You can stop the listing by pressing < ESC> . The program is listed through the COM1 serial port
unless you specify otherwise.
The basic variations are:
LIST
list the entire program to COM1
/
quick version of above
LIST #1
list the entire program to COM1
LIST #2
list the entire program to COM2
LIST.
l is t 1 6 li ne s at a t im e
LIST!
list program with no line numbers
For simplicity the next group of variations shown for COM 1:
LIST 50
list only line 50
LIST 100– 500
list from the line 100 to line 500
LIST 220–
list from line 220 to the end of the program
LIST – 50
list from the beginning of the program to line 50
To comb ine the two groups of va riations:
LIST #2, 10– 200
list through COM2 fr om line 10 to line 200.
LIST.
lists 16 lines at a time. Pressing the space bar will list the next 16 lines. Pressing any other
key will abor t the listing. The com mand is va lid only on the C OM 1 port.
You can use the optional line numbers to define a range.
RELATED:
none