Source[<n>]]:apply:square – RIGOL DG1000Z Series User Manual
Page 91
RIGOL
DG1000Z Programming Guide
2-79
[:SOURce[<n>]]:APPLy:SQUare
Syntax
[:SOURce[<n>]]:APPLy:SQUare
[<freq>|DEFault|MINimum|MAXimum[,<amp>|DEFault|MINimum|MAXimum
[,<offset>|DEFault|MINimum|MAXimum[,<phase>|DEFault|MINimum|MAXimum]]]]
Description
Set the waveform of the specified channel to square waveform with the specified
frequency, amplitude, offset and phase.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
1|2
1
<freq>
Real
1uHz to 25MHz
1kHz
<amp>
Real
Refer to the “Explanation”
5Vpp
<offset>
Real
Refer to the “Explanation”
0V
DC
<phase>
Real
0° to 360°
0°
Explanation
When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related
parameters of CH1 by default.
The range of <amp> is limited by the “Impedance” (
) and “Frequency/Period” settings. The range of
<offset> is limited by the “Impedance” and “Amplitude/High Level” settings.
Example
:SOUR1:APPL:SQU 100,1,2,3 /*Set the waveform of CH1 to square with 100Hz
frequency, 1Vpp amplitude, 2V
DC
offset and 3°
start phase*/
Related
Commands
:OUTPut[<n>]:IMPedance
:OUTPut[<n>]:LOAD