Rose Electronics UltraMatrix AV DVI 4 - Manual (Page 12)

8 ULTRAMATRIX AV INSTALLATION AND OPERATIONS MANUAL
Figure 6. Rose Control Switching Matrix
The left column lists the inputs 1-4 and the right column lists the outputs 1-4.
The input and output names can be changed by highlighting the name to
change and re-naming it.
Switching using Rose Control Switching Matrix
Using the switching matrix is the easiest way to route a video input to any or
all outputs. Click on the cross-point where the input to route (vertical
numbers 1-4) and the output destination (horizontal numbers 1-4) cross and
the switch is executed immediately. The example shown in figure 7 shows
input #1 routed to output #1 and #3, input #2 routed to output #2, and input
#3 routed to output #4. An input can be routed to multiple outputs, but an
output can only be connected to one input.
Figure 7. Example of Switching Matrix
To select multiple outputs to connect to a single input, hold the control (Ctrl)
key down and click on the individual output numbers needed. Next, click on
the input number to route to the selected outputs.