Rose Electronics UltraMatrix AV DVI 4 - Manual (Page 13)

ULTRAMATRIX AV INSTALLATION AND OPERATIONS MANUAL 9
Example:
To route outputs 1, 2, and 4 to input #2, hold down the control key, click on
the output numbers 1, 2, and 4.
When all outputs are selected, click on input #2.
To select multiple adjacent outputs to connect to a single input, click on the
first output number, hold down the shift key, and then click on the last output
number.
Example:
To route outputs 1-3 to input #3 click on output number 1, hold down the
shift key and click on output number 3, then click on the input #3.
To route a single input to all outputs, hold down the control key and click on
an input number.
Example:
To route input #4 to outputs 1-4, hold down the control key and click on the
input #4. Outputs 1-4 will be routed to input #4.
Recording Macros
On the right side of the RoseControl switching matrix there are up to 50
macro tabs that are used to save and play back macros. These macros
store a set sequence of routes.
To record a macro:
1. Click on the Record button. A blinking “recording” message below
this button will be displayed to indicate that all routes are being
recorded.
2. Select the desired cross points. There is no limit on the number of
routes you may record.
3. If you click a macro button while in the record mode, the macro will
be executed, and these routes will be added to the recording. This
makes it possible to combine the routes of two or more macros into
one bigger macro.
4. When finished, click the “Save Macro” button. You will be instructed
to then click on one of the macro buttons. Doing this will save the
recorded routes to that button.
To cancel saving the macro, click the “Cancel Save” button.
5. To play back a macro, simply click on one of the 50 macro buttons.
Use the scrollbar to bring any of these into view.
6. The macros are automatically saved in the current configuration file.
They are also saved when you select the File/Save Configuration...
menu.