Rose Electronics UltraMatrix AV DVI 4 - Manual (Page 8)

INSTALLATION AND OPERATION
4 ULTRAMATRIX AV INSTALLATION AND OPERATIONS MANUAL
Installation and Set-Up
Please refer to the safety section first before proceeding with any installation
or configuration or the UltraMatrix AV. It is recommended that the following
installation procedure be followed. All equipment (UltraMatrix AV, Monitors,
and PC’s) should be powered off until all cabling is connected. Once
UltraMatrix AV learns the specifications of the connected monitors, they can
be disconnected if needed and the computers will still boot without a monitor
connected. The figure below shows a typical installation.
Figure 4. Typical Installation
Installation consists of four steps:
1. Connect up to 4 video sources to the units DVI inputs
2. Connect up to 4 monitors to the units DVI outputs
3. Connect a remote computer to the units DB9 serial input
4. Install RoseControl software on the remote computer