Rosen Aviation 1700 Series : 17 inch SlimLine - Manual (Page 14)

17” SlimLine LCD Page 13
Installation Guidlines
Note: Each mounting hole includes a 10-32 screw. To install the monitor,
remove only the screws that will be used to install the monitor. Do not
remove the 4-40 flathead screws.
Note: Application requires listed connector backshell (Positronics
D37000GVL-1023.0) due to space constraints and 21WA4 combo
connector.
MONITOR REAR
Cooling and Ventilation
The monitor is cooled by the flow of air, or natural convection.
Special care must be taken with the installation to provide a
proper environment for air flow.
• Monitor vents: The unit is designed with vent openings
on the top, bottom, and rear surfaces. The entire top
vent, and either the entire bottom or entire rear vent
must be unobstructed for a minimum of one inch (1").
The vents must also be ducted to free air.
• Ducting: The installation must provide for an inlet duct
(at bottom or rear), and an exhaust duct at the top. Each
of these ducts must have a minimum of four (4) square
inches of cross-sectional area.
!
Warning! Maximum screw depth:
Top .75 inches
Bottom .75 inches
Sides .75 inches
Rear .50 inches
Note: Display backlight will shut down if the internal temperature
reaches 140 ° F