Subaru Robin PKX201 - Manual (Page 86)

High Pressure Pumps - PKX Service
- 86 -
45. When replacing the gasket make sure the gasket is
fl at and not kinked. The gasket does not have a
specifi ed side to place on pump housing.
46. Re-install discharge nozzle and torque to 4.5 to 6
ft.
lbs.
47. If it becomes necessary to remove the inlet nozzle,
the following procedures are recommended.
Loosen the three bolts that hold the casting to the
outer pump housing.
48. Lift the outer cover and gasket from the pump
housing. Note position of gasket. Check gasket for
cracks, nicks or other areas that might cause a air
leak.