KEPCO KLP Series Developer's Guide, Rev 1 - Manual (Page 72)

5-10
KLP-DEV 031113
5.5 DEMONSTRATION PROGRAM USING THE VXI PLUG&PLAY DRIVER
The demonstration program is intended to illustrate the use of the VXI plug&play functions included with
the KLP power supply. The demonstration program is installed under Windows by running SETUP.EXE.
The program as written presents a virtual front panel for control of a single KLP power supply
The following paragraphs describe the windows and the associated controls and indicators provided with
the demonstration program. For additional details regarding operation of the KLP, refer to the operating
instructions for local and remote mode found in the KLP User Manual.
5.5.1 GPIB SETUP
After the program is installed, double click on KLPCTRL.exe to run the program.When the GPIB
Setup window opens, enter the GPIB address of the KLP power supply to connect to the VXI
plug&play interface. If the power supply type is correct, the Continue button will open the Main
Panel (Figure 5-5).
FIGURE 5-4. GPIB SETUP WINDOW
Once you are connected, you will see the Main Panel (Figure 5-5).
FIGURE 5-5. MAIN PANEL WINDOW