KEPCO MAT Full Rack MAT 6V, 15V, 25V AND 36V MODELS User Manual
Kepco, Mat full rack power supply, Model
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- SECTION 1 - INTRODUCTION
- 1.1 Scope Of Manual
- 1.2 General Description
- 1.3 Specifications, Electrical
- 1.4 DC Output Ratings For 1/3, 2/3 And Full Rack Modules
- 1.5 Miscellaneous Features
- 1.6 Accessories
- 1.7 Safety
- SECTION 2 - INSTALLATION
- 2.1 Unpacking And Inspection
- 2.2 Terminations
- 2.3 AC Input Requirement
- 2.4 Cooling
- 2.5 Installation
- 2.6 Grounding
- 2.6.1 Safety Grounding
- 2.6.2 DC (Output) Grounding
- 2.6.3 Power Module To Load Interface
- 2.6.4 Load Connection, Local Error Sensing
- 2.6.5 Load Connection With Remote Error Sensing
- 2.7 Operating Configuration
- 2.8 Preliminary Check-out
- 2.8.1 Example 1: Full Scale Voltage Check
- 2.8.2 Example 2: Full Scale Current Check:
- 2.8.3 Example 3: To Reset the Power Module
- SECTION 3 - OPERATION
- 3.1 General
- 3.2 Introduction To Controlling The MAT Power Module Output
- 3.2.1 MAT/Power Module Controller System
- 3.2.2 MAT/TMA Pc-27 System
- 3.3 Automatic (Tracking) Control Of The Crowbar Level
- 3.4 Power Module Controller/MAT Time Delays (To Obtain A Valid Status):
- 3.5 Power Loss Circuit
- 3.6 Remote Programming
- 3.6.1 General
- 3.6.2 SCPI Programming
- 3.6.2.1 SCPI Program Example
- 3.6.3 CIIL Programming
- 3.6.3.1 Examples Using CIIl To Program The MAT Power Module.
- TABLE A-1. CIIL Subsystem Command/query Index
- TABLE A-2. CIIL Error Messages