Eureka 4750A - Manual (Page 12)

12
ENGLISH
How To Assemble
(CONTINUED)
Step 7: (FIG. 7) Then wrap the hose up and over the hose hook on the
handle
●
G as shown. Plug the end of the hose into the hose retainer hole on
the base
●
E (FIG. 7a) and then snap the hose into the hose holder on the
tool caddy
●
H . (FIG. 7b)
FIG. 7
FIG. 8
FIG. 9
FIG. 7b
FIG. 7a
●
F
●
G
●
H
●
E
FIG. 8a
●
B
●
A
●
C
Step 8: (FIG. 8) Place the bag container
●
F on the vacuum by aligning
the bottom groove of the bag container against the tab on cleaner base.
Pivot the bag container up against cleaner and push to secure as it snaps
into place.
Step 8A: (FIG. 8a) (some models only) Place Power Paw™ stair
brush in slot in the special handle holder.
Step 9: (FIG. 9) Place the wand/crevice
●
A /
●
B tool in the wand holder on
the side of the vacuum. Store the dusting brush
●
C on the brush holder
on the back of the handle.
NOTE: Screws must be installed to properly secure the parts of the vacuum.