While in use •on switching on, On first use – DE DIETRICH DTI1177X User Manual

Page 16

Advertising
background image

16

EN

4 / SPECIAL MESSAGES, DIFFICULTIES

In case of breakage, cracks or even light fissures in the vitroceramic glass, take out
the fuses or turn off the circuit breaker for your hob to avoid the risk of electrical
shock.

Contact the After-Sales Service Department.

The hob does not operate and
the indicator lights on the con-
trol panel do not light up.

The hob is not working and
another message is displayed.

The hob does not function, the
information is

displayed.

The machine is not connected to
the power source. The power
source or connection is defective.

The electronic board is func-
tioning poorly.

The hob is locked

Inspect the electrical cir-
cuit breaker and fuses.

Call the After-Sales
Service Department.

See chapter on using the
child safety system

The hob has stopped operating
and is beeping approximately
every 10 seconds and a

or

F7 is displayed.

A series of small

or F7 is

displayed.

After turning on a heating zone,
the indicator lights on the con-
trol panel continue to flash.

The saucepans make noise dur-
ing cooking.
Your hob makes a clicking
sound during cooking.

The fan continues to function a
few minutes after your hob is
turned off.

There was an overflow or an
object is in contact with the
control panel.

The electronic circuits have
overheated.

The cookware used is not suit-
able for induction or is less than
12 cm in diameter (10 cm on a
16 cm area).

This is normal with some types
of cookware. This is caused by
the transfer of energy from the
hob to the cookware.

Cooling of the electronic com-
ponents.
Working normally.

Clean the hob or remove
the object, then begin
cooking again.

See “Inserting” section.

See section on cookware
for induction.

Nothing. There is no risk,
neither to your hob nor to
your cookware.

Nothing.

•While in use

•On switching on

YOU OBSERVE THAT:

POSSIBLE CAUSES:

WHAT SHOULD YOU DO?

YOU OBSERVE THAT:

POSSIBLE CAUSES:

WHAT SHOULD YOU DO?

POSSIBLE CAUSES:

WHAT SHOULD YOU DO?

A special lamp appears.

Your installation blows a fuse.

Only one side works.

The hob produces an odour dur-
ing the first cooking sessions.

Working normally.

The electrical connection of
your hob is incorrect.

New appliance.

Nothing, the light disappears
after 30 seconds.

Check that it is set up
properly.
See the “Electrical
Connection” section.

Nothing. The smell will dis-
appear after several uses.

•On first use

Advertising
This manual is related to the following products: