Amprobe TMD-52 Thermocouple-Thermometer - Manual (Page 13)

6
“” Button
The “” key changes setting digit. (See “SET mode”
later in this manual.)
“ q ” Button
The “q” key decreases the setting value. (See “SET
mode” later in this manual.)
“SET” Button
Relative value set, Hi/Lo Limits value set and Cool
Junction Compensation value set. Press “SET” key
to enter SET mode. The LCD displayed “SET” and set
annunciator is displayed.
Set Relative value
Press “SET” key to enter SET mode, then Press “REL”
button to set relative value. First, “REL” displayed on LCD
and wait for one second to enter SET REL mode.
SET”, “REL” and “T1” annunciator are displayed.
Press “p”, “q” to increase or decrease blink digit, press
“” to change blink digit.
If have no blink digit, press “p”, “q” to set the positive
or negative for this relative value. Then press “ENTER”
key, stored the relative value for T1, enter set relative
value for T2. In this Relative SET mode, the value can not
be ±1999.9 counts. If this value more than ±1999.9 counts,
“Err” displayed and re-input.
Set Hi/Lo Limit value
Press “SET” key to enter SET mode, then press Hi/Lo
button to set Hi/Lo Limit value. “SET”, “LIMIT”, “Hi” and
“T1” annunciator are displayed.
Press “p”, “q” to increase or decrease blink digit, press
“” to change blink digit.
If have no blink digit, press “p”, “q” to set the positive
or negative for this Hi/Lo Limit value. Then press “ENTER”
key, stored the Hi Limit value for T1, enter set Lo Limit
value for T1. In this Hi/Lo Limit SET mode, the value can