Datalogic QuickScan Lite QW2100 - Manual (Page 285)

Product Reference Guide 275
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of Table 3 .
The settings in this table are as applied to a standard RS-232 interface. See Table 4 for a
listing of default exceptions to this list as appled to other interface types. Page references
are also provided for feature descriptions and programming bar codes for each parameter.
A column has also been provided for recording of your preferred default settings for these
same configurable features.
Table 3. Standard Defaults
Parameter Default Your Setting Page Number
General Features
Host Commands — Obey/Ignore Obey 15
USB Suspend Mode Disable 16
Double Read Timeout 0.4 Second 17
Label Gone Timeout 160 ms 19
Power Save Mode Enabled 20
Sleep Mode Timeout Disabled 21
Power On Alert 4 Beeps 22
Good Read: When to Indicate After Decode 23
Good Read Beep Type Mono 24
Good Read Beep Frequency Medium 25
Good Read Beep Length 80 ms 25
Illumination Control
Illumination Off
during beep
27
Good Read Beep Volume High 28
Good Read LED Duration
LED on until
next trigger pull
29
Scan Mode Trigger Single 30
Stand Mode Triggered Timeout 0.5 Seconds 31
Scanning Active Time 5 Seconds 33
Stand Mode Flash Disable 33