MIDEA MAP08R1CWT - Manual (Page 14)

Type 2: Sliding window installation
1. Cut the adhesive foam seal A and B strips to the
proper lengths, and attach them to the window sash
and frame as shown.
Window slider A
Window slider B
(if required)
Foam seal B
(Adhesive
type-shorter)
Foam seal A
(Adhesive
type)
Foam seal C
(Non-adhesive type)
2 Screws
Security
Bracket
2. Insert the window slider assembly into the window
opening.
3. Cut the non-adhesive foam seal C strip to match the
window height. Insert the foam seal between the glass
and the window frame to prevent air and insects from
getting into the room.
4. If desired, install the security bracket with 2 screws
as shown.
5. Insert the window slider adaptor into the hole of the
window slider.
NOTE
To ensure proper functioning, DO NOT overextend or bend the hose. Make sure that
there is no obstacle around the air outlet of the exhaust hose (in the range of approx.
20 inches) in order for the exhaust system to work properly. All illustrations in this
manual are for explanation purposes only. Your air conditioner may be slightly
different than the illustrations shown here.
Ins
tallation Ins
tructions
Page 14